Furnace Repair Langley BC
Langley Furnace Repair — City, Township, and Everything Between
Langley Township's large-lot residential areas — Willoughby Heights, Walnut Grove, Fort Langley, Murrayville — tend to have bigger homes with older single-stage gas furnaces running hard all winter. Langley City has a different mix: smaller homes, condos, and townhomes where space constraints and aging systems create their own set of challenges.
In both cases, we can usually get there the same day, diagnose properly, and fix it on the first visit. We carry common parts for Carrier, Lennox, Trane, Goodman, Bryant, Rheem, and Napoleon — the brands that dominate Langley's housing stock — and we provide a written quote before touching anything.
Common Furnace Repairs in Langley
Gas Furnace Not IgnitingFailed igniter is the most common cause. We also check gas pressure, gas valve operation, and control board fault codes before replacing anything.
Furnace Keeps Shutting OffShort-cycling is almost always an airflow or overheating issue. We check filters, return vents, and limit switch operation — and fix the underlying cause.
High-Efficiency Furnace ErrorsLangley's newer homes commonly have 96%+ condensing furnaces. Condensate drain blockages, pressure switch faults, and inducer motor issues are specific to these systems — we know them well.
Old Furnace Running PoorlyA Langley furnace over 18 years old may cost more to maintain than it's worth. We give you an honest repair-vs-replace assessment with real numbers — no pressure.
Thermostat and Wiring IssuesSometimes the furnace is fine and the problem is a failed thermostat, blown fuse, or loose wiring connection. We diagnose the full system, not just the box.
Emergency Furnace RepairNo heat in winter is urgent. We prioritize emergency calls and route a technician to Langley as fast as possible. Call even after hours.
How much does furnace repair cost in Langley? +
Furnace repair in Langley typically runs $150–$900 depending on the component. Igniter replacement is $180–$320, flame sensor cleaning or replacement $120–$220, control board replacement $350–$750, heat exchanger inspection $250–$450. The $89 diagnostic fee is waived if you proceed with repair.
Do you service furnaces in both Langley City and Langley Township? +
Yes. We serve all areas including Willoughby Heights, Walnut Grove, Fort Langley, Murrayville, Aldergrove, and Langley City centre.
My Langley furnace keeps shutting off — what's causing it? +
A furnace that repeatedly shuts off (short-cycling) is usually overheating due to a dirty filter, blocked return vents, or a failing limit switch. It can also be a control board fault or a pressure switch problem on high-efficiency condensing furnaces. We diagnose on the first visit and give you a written quote before any work begins.
Also Serving Near Langley