Furnace Installation Surrey BC
New Furnace Installation — Done Right the First Time
A new furnace is a significant investment — and an undersized, oversized, or improperly installed unit will cost you money in energy waste, poor comfort, and premature failure. Surrey HVAC Specialists performs full Manual J load calculations for every installation to ensure your new furnace is properly matched to your home's actual heating demand.
We install gas furnaces from major manufacturers including Lennox, Carrier, Bryant, and Goodman. All installations are permitted through the City of Surrey and inspected by a BC Safety Authority-certified inspector — we handle everything, including the paperwork.
Furnace Types We Install
Single-Stage Furnaces
Lowest upfront cost. Runs at full capacity or off. Suitable for smaller homes or milder climates. AFUE 80–96%.
Two-Stage Furnaces
Runs at 60–65% capacity most of the time, full capacity only on the coldest days. Better comfort, lower bills. AFUE 96%+.
Modulating Furnaces
Adjusts output in 1% increments. The most efficient and comfortable option. Virtually eliminates cold spots and temperature swings. AFUE 98%.
High-Efficiency Condensing
All new Surrey installations meet or exceed BC's 95% AFUE minimum. Condensing furnaces recover heat from exhaust gases, significantly reducing gas bills.
Furnace + AC Combinations
Installing AC at the same time as a furnace saves on labour and often qualifies for combined equipment discounts. We quote both together.
Furnace + Heat Pump Hybrid
A heat pump handles most heating, with the gas furnace as backup on the coldest days. Often the most cost-effective long-term option with CleanBC rebates available.
Our Furnace Installation Process
- In-home assessment — We measure your home, assess insulation, check existing ductwork, and calculate your actual heating load. This takes 30–45 minutes and is completely free.
- Written quote — You receive a fixed-price quote covering equipment, installation, permit fees, and disposal of your old unit. No hidden fees.
- Permit pulled — We pull the BC Safety Authority permit before we start. Non-permitted furnace installations are not covered by home insurance and void manufacturer warranties.
- Professional installation — Red Seal gas fitter installs and commissions the unit. Typically 4–6 hours for a straightforward replacement.
- Inspection and sign-off — We coordinate the BCSA inspection and ensure you receive your inspection certificate.
- Walkthrough — Before we leave, we walk you through operating your new thermostat, filter replacement schedule, and what maintenance is needed to maintain the warranty.
Surrey furnace installation requirements: BC building code requires a permit for any new furnace installation or replacement. Any work done without a permit is illegal, voids your equipment warranty, and may not be covered by homeowner insurance in the event of a fire or incident. Always verify your contractor pulls a permit — we do this as a standard part of every job.
When Should You Replace Rather Than Repair?
If your furnace is over 18 years old and requires a repair costing more than $500, replacement is almost always the better financial decision. A high-efficiency replacement reduces your annual gas bill significantly — Surrey homeowners on FortisBC typically see 20–35% reductions in heating costs when moving from an old single-stage 80% AFUE unit to a new 96–98% modulating furnace.
If your furnace has a cracked heat exchanger — which allows carbon monoxide to enter your home's air supply — replacement is required immediately regardless of age.
How much does furnace installation cost in Surrey? +
New furnace installation in Surrey typically ranges from $3,500–$6,500 depending on furnace efficiency tier, brand, and any ductwork modifications required. A standard mid-efficiency replacement (same location, existing ductwork in good condition) is usually $3,500–$4,500. High-efficiency modulating units with new venting run $4,800–$6,500. We provide free written quotes with no pressure to proceed.
How long does furnace installation take? +
A standard furnace replacement typically takes 4–6 hours. More complex jobs — where the old furnace is in a tight space, venting needs to be rerouted, or ductwork requires modification — can take a full day. We schedule installations so your home is never without heat overnight.
Do I need a permit for a new furnace in Surrey? +
Yes. A BC Safety Authority gas permit is required for any new gas appliance installation in Surrey, including furnace replacements. The permit fee is included in our quote. Any contractor who installs without a permit is working illegally — and your equipment warranty and homeowner insurance may be void as a result.
Should I get a furnace or a heat pump? +
For most Surrey homes, a heat pump is the most cost-effective choice over 10–15 years — especially when CleanBC rebates are factored in. Heat pumps also provide cooling in summer, which a furnace alone cannot. However, if you have unusual heating demands, poor insulation, or a specific duct configuration, a high-efficiency gas furnace may be the better fit. We'll model both options during your free in-home quote so you can compare on actual numbers.